RC10Talk - The Net's Largest Vintage R/C Community

Was wondering if anybody knew if these would fit the top loading gold shocks. If I knew the diameter that would be great. Normally I would just buy them and see but they are a little pricey so wanted to check here first.

Shock Spring Cups

Says there for the Losi 8, which is 1/8 scale. Probably way to big. HG Hammad Ghuman made aluminum shock parts for the RC10.........a bit hard to find though.

Googled a pic for ya..

I see. OK. Thanks for the info.

check ebay item181176984173 they are for b4 shocks but they should work

Cool just bought a set. Thanks

let me know how those fit please.

I thought losi springs were always larger diameter than associated but they say it works for both. Guess you will find out

TO USE losi springs u haft to use spring ring top and losi spring cup bottom,If not the spring pops up over top spring clamp or over the bottom cup.don

Agreed, but this is the other way around. That's why I was wondering if it will really fit associated springs. Worst case you could use Losi's.

Could turn them down on machine to fit the springs the reanno them.don

gomachv wrote:Agreed, but this is the other way around. That's why I was wondering if it will really fit associated springs. Worst case you could use Losi's.

And then you don't wear the ano off the outside of your 1:32 body by using a spring that imo, is too small. Once I started using losi springs, I can't go back to the tiny ae ones. My nit-pickiness, but I have this theory that you get a much smoother shock when the spring isn't bending sideways and scraping on the shock body.

That's a pretty good point. I had noticed that, the scraping of the shock body. I'll try both.