RC10 SE
Posted: Sat Sep 28, 2013 6:04 pm
Some time ago I built the front nose up with RPM Losi SE Pro (?) arms. It is a work in progress and needs a few parts to finish. The width up front is spot on. The wheelbase is approximately 1/8" longer depending on suspension setup.
As shown, the steering tie rods rub the camber tie rods when the suspension is fully compressed. This is partly due to the fact that I added nylon spacers under the bell cranks because the bell cranks were rubbing the chassis
In the meantime, I stole from the B4 design and placed the ball studs on the front of the shock tower to eliminate rubbing. I will also try other bell crank options. I will swap out the front 15 degree carriers for 30 degree. I need to locate one 1 7/8" hinge pin. Lastly, I need to drill and tap nose tubes.
As shown, the steering tie rods rub the camber tie rods when the suspension is fully compressed. This is partly due to the fact that I added nylon spacers under the bell cranks because the bell cranks were rubbing the chassis
In the meantime, I stole from the B4 design and placed the ball studs on the front of the shock tower to eliminate rubbing. I will also try other bell crank options. I will swap out the front 15 degree carriers for 30 degree. I need to locate one 1 7/8" hinge pin. Lastly, I need to drill and tap nose tubes.