RC10Talk - The Net's Largest Vintage R/C Community

I am not sure if this is the correct place for this question but here it goes. Does anybody know where to find a new belt for the Track Master Turbo Glide trans? I picked one up recently and completely rebuilt it. I refinished the carbon and polished all the aluminum parts up. It's so pretty but I want to run it on my RC10. Any help would be much appreciated.

SDP/SI is your friend.

Need numbers off the original, surely someone out there has one!

I may have a few.

I can't remember if there's any writing on the belts or not. I'll post them tomorrow if I find some.

If nothing else maybe a tooth count and belt pitch

None of the belts on my complete trannies have numbers, but I have a NIP belt with either I49U or 149U and MADE IN U.S.A. stamped on it.

The belt has 25 teeth and 25 grooves And it's about 6mm or 1/4" wide with a 5mm pitch.

The part number from Track Master was 7107.

Instructions found here:
http://www.rc10talk.com/viewtopic.php?f=7&t=4688

I know this is an old thread but I've finally got an answer for it! The belt is an XL profile, 1/4" wide, 25 tooth.

Anyone ever found an actual source with a part number or direct link to these belts?

Thanks,
Jake

Like mentioned above, the SDP/SI site is a great resource for some hard to find parts.

One of these belts they have may work...

Imperial version: http://shop.sdp-si.com/catalog/product/?id=A_6B_3-025025

Metric version: http://shop.sdp-si.com/catalog/product/?id=A%206B%203M025060