Page 1 of 1
Compatible Custom Works Pins
Posted: Sat Jan 04, 2014 9:40 am
by mrlexan
Anyone know another manufacture that carries the same hinge pin dia as Custom Works? AE and Losi are too big. The CW pins have been on back order for a long while and I am missing a couple. I've got tons of loose pins, but haven't been able to find a matching diameter. I searched the forum and didn't see it asked or discussed.
Thanks.
Jay
Re: Compatible Custom Works Pins
Posted: Sat Jan 04, 2014 12:00 pm
by jwscab
3mm pins are smaller than 1/8" so maybe a metric car like hpi or something?. Also later associated b4 t4 etc use a smaller pin. 7/64" or something like that. No groove for e-clips though.
If you can get dimensions and its a standard drill blank size I can make some for you.
Re: Compatible Custom Works Pins
Posted: Sat Jan 04, 2014 12:11 pm
by Charlie don't surf
Yokomo- I have tons of loose Dominator pins too Jay-
Re: Compatible Custom Works Pins
Posted: Mon Jan 06, 2014 7:47 am
by mrlexan
Thanks guys, I'll check my stash of Yokie pins.