RC10Talk - The Net's Largest Vintage R/C Community

I have had this old roller for years, I'm cleaning it up to do something with it. Just need some info on what it is.

Thanks for any help.

i'mm 99.9% sure it's a bolink. i'm not sure which model. they had the eliminator, invader, and i think another one. but i'm near positive it's a bolink.

Looks like a Bolink Eliminator set up for a Superspeedway quick-change battery system. Looks like the QC setup is missing, though.

Cut down or narrowed Bolink?

wow old bump..

body mounts are bolink.
shocks are bolink.
rear pod is bolink.

in the end i would have to agree with everyone else that its a bolink.

Lol, sorry I am new and didn’t notice the date, at work, the field was wet, sun in my eyes, I really do apologize but perhaps I just made someone’s day that has been diligently checking their thread for the past 3 years eagerly awaiting a third response…… again sorry ill be more careful, I just picked one up off the bay and was researching what I could as Bolink doesn’t seem to be a super popular candidate for a restoration.

That's a modified Eliminator. The QC had a little different chassis. Also the front axle plate is a custom homemade looking jobby.

Your right about the front axel but it is not a qc it is a eliminator enduro they came with fiberglass battery trays you could swap out the qc used associated rc10 cups upsidedown and battery packs were replaced fron underneth.

You are correct sir! I just went and looked at my old Eliminator chassis. It has large cutouts on the side there just behind the front axle mounts. Good call.