RC10Talk - The Net's Largest Vintage R/C Community

Now, this is an old project !

A all new complete RC10 Composite Craft / RPM World 1991 , I had an Hydradrive and the Yokomo wheel adapter
On this one I use a Houge Enterprise steering system !

One word: gorgeous

do you have any new or mint 2.2 yokomo wheels for sale, any color is good?
thanks

sweet.

Very clean and nice. I have a question though, do you have the losi hydra drive installed on the buggy in these photos? If you do, how did you get your RPM gear cover to fit?

shodog wrote:Very clean and nice. I have a question though, do you have the losi hydra drive installed on the buggy in these photos? If you do, how did you get your RPM gear cover to fit?

Jim, RPM made the standard gear cover and a special one for the hydra-drive unit, I got one on my whity white RPM chassis too, it's a direct fit

I am aware of the two different covers but I can't get my stealth hydra cover to fit over the hydra drive unit.

there were 2 rpm covers for the hydra drive if memory serves, one for a rc10, one for a b2/3, i think they look nearly identical and they arent identifiable to even a keen eye, but the holes are different.

shodog wrote:I am aware of the two different covers but I can't get my stealth hydra cover to fit over the hydra drive unit.

Ok, I was also wondering how you could not be aware of that, lol, sorry Jim Then what's the problem in a few words?

basically the gear comes into contact with the cover. I made sure that the hydra backing is seated properly on the shaft but it looks like it sits out too far.

hmm.. got me on that one.. maybe the wrong spring? one is for a slipper eliminator, one is for use with the hydra. think the silver one is the right one. i have 1 sitting on a car now, and another that is in peices but just put it together and it fits fine

Post a picture Jim, it will help... maybe you just didn't insert the hydra unit to the deep end, it's a tight fit...

Hi Guy's

Yes for sure I have the hydradrive under this special RPM cover, if you check the picture of my RPM Team Car, you are able to see the standard RPM gear cover, for slipper !

Asa

Yes I have extra 2.2 Yokomo wheels, in White, but to be sure, that's to fit a RC10 (same than picture) or a Yokomo ?

Hi kenooze, I would be interested in some 2.2in yokomo rims with similar offset like the ones you have on this car as well. Ofcourse, Asa has first crack at them, then I'll take a couple if you still have some Let us know what you got, thanks!