RC10Talk - The Net's Largest Vintage R/C Community

does anyone know where i can source some new white plastic/nylon rod ends ( zc402) from, or an alternative that will fit.

In the wanted section?

Traxxas rod ends fit on the yokomo balls if you have the balls, or just use the traxxas balls. RPM makes white ones but you need a beefy turnbuckle like 3.5mm or maybe even 4mm.

These are possibly the most wanted Yokomo parts, so unless You´re one heck of a charmer or just loaded with cash, it´s going to be long quest My advice is to buy a good condition YR4 and use that as a donor.

I picked up a yr4 nitro just for the bits, it went for $15 on eBay. These things pop up once in a while, I've paid a whole lot more for a bag of parts than I have for a complete car a few times.

you can also 'fake' it by using the associated shock ends and balls also.

DennisM wrote:These are possibly the most wanted Yokomo parts, so unless You´re one heck of a charmer or just loaded with cash, it´s going to be long quest My advice is to buy a good condition YR4 and use that as a donor.

x2

hmmmmmm I just sent someone 2 NIP packs

Charlie don't surf wrote:hmmmmmm I just sent someone 2 NIP packs

Tsk tsk, You´re just so easy to charm

DennisM wrote:

Charlie don't surf wrote:hmmmmmm I just sent someone 2 NIP packs

Tsk tsk, You´re just so easy to charm

It was a buddy....Just don't recall which one

I really didn't know that they were that rare, not that it would have mattered

Guess I need to "stock up".

The YR4 rod end part number you want is ZR-007. if youre talkin suspension

i suppose that these are as rare as hens teeth as are most works 91 parts

anyone know if the Yokomo MX4 ZM-400 rod ends are the same size

brian s wrote:anyone know if the Yokomo MX4 ZM-400 rod ends are the same size

Yes

http://www.end-of-line-rc.com/cars/option-parts/yokomo/mx4/mx4-upper-iarm-set.html

Comes with balls and rod ends and turnbuckles, although they are the wrong length for a YZ 10.