Page 1 of 1
novak gtb2 with x drive
Posted: Thu Jan 30, 2014 1:44 pm
by rctenracer
New out of box. With power on I am getting a error code red and green light solid. Check input signal harness. I have done that and switched out the harness . Harness is good I checked continuity and it passed. I am stuck at this point . Any sugestions before I send back to novak .
Re: novak gtb2 with x drive
Posted: Thu Jan 30, 2014 2:51 pm
by 8rad
What does the manual say about that code?
Re: novak gtb2 with x drive
Posted: Thu Jan 30, 2014 3:50 pm
by rctenracer
Says check input signal harness and go to step 3.
Re: novak gtb2 with x drive
Posted: Thu Jan 30, 2014 6:43 pm
by 8rad
Well you say you checked the signal harness, have you tried another receiver?
Re: novak gtb2 with x drive
Posted: Fri Jan 31, 2014 11:35 am
by Blacktiger355
Have you made sure the harness is not flipped backwards on the 3 pins of the esc? With the sensor plug and harness pins facing you, the far right pin of the harness should be the signal or white wire, middle is red, left is black.
Re: novak gtb2 with x drive
Posted: Fri Jan 31, 2014 1:46 pm
by rctenracer
Well it works now that I bound the reciever .
Boy do I feel stupid.
Re: novak gtb2 with x drive
Posted: Sun Feb 02, 2014 4:24 am
by Blacktiger355
We have all done it.
Re: novak gtb2 with x drive
Posted: Sun Feb 02, 2014 10:53 am
by dldiaz
Blacktiger355 wrote:Have you made sure the harness is not flipped backwards on the 3 pins of the esc? With the sensor plug and harness pins facing you, the far right pin of the harness should be the signal or white wire, middle is red, left is black.
I've made this mistake before, I was super frustrated, called the manufacturer and all - only to have the kid on the phone ask me about the order of the black/white/red wires on my receiver...