RC10Talk - The Net's Largest Vintage R/C Community

I had an idear last night about building an rc10 graphite car a b2/3 front kick plate and front and. And leave everything else rc10 with klein rear arms. Just kind of thought about taking the woin a step further and using off the shelf parts to build an evan narrower front end rc10. So i guess my question is has anyone tried it? I know i seen that guy made a complete b3 with a graphite chassis plate. But i like the idea of using the rc10 rear end. I even thought about possably drilling and cutting the chassis to use b2/3 rear arms and still using the rc10 rear bulkhead and stealth. But that would all be figured out once the project starts. I emaild rc carbonworks and they said they have no problem making me a chassis withot any holes except the rear bulkhead and stealth holes. I know i will have to cut down the front of the chassis some because the kick plate is quite a bit narrower. Just figured id see some opinions on how well it would word and if it had ever been tried

yep, it has been done before. there are a few threads in the forums with hybrid type cars.

Even if its been done we like to see other guys put their spin on any build so go for it.don

I've got a B3 front end sitting around too. I've been tempted to do the same thing but with a Bullet Racing Powerglide belt drive and trailing arms at the rear. Then again I've also got a B4 front end too.