RC10Talk - The Net's Largest Vintage R/C Community

I had people saying to me that they didn't like the bright flashy colors. They also thought white was too bright while black was too dark. They wanted something that was like a pale black.

So today there is now grey in all the current parts except for the Zerda crossbars. Going forward all the new parts in the works will also be available in grey.

http://sabulatech.com/storefront/category.php?id_category=112

Grey, it is the new black!

(nobody really asked for grey)

That sounds like great news.

Can I ask if it would be possible to print a Mugen Bulldog roll cage? I know many people are desperate for one.

any chance you would consider printing 3 degree rear arm mounts for the rc10?

popboy905 wrote:any chance you would consider printing 3 degree rear arm mounts for the rc10?

X2

J.M. wrote:That sounds like great news.

Can I ask if it would be possible to print a Mugen Bulldog roll cage? I know many people are desperate for one.

Looking at pictures online, those look too be all one piece. They would be hard to print like that and maintain good strength. That and it is probably to large for my print bed.

popboy905 wrote:any chance you would consider printing 3 degree rear arm mounts for the rc10?

That is probably in the realm of a good part to try. I have been starting to migrate my way to parts like that on the Losi kits. I would need a sample part to get all the measurements from.