Page 1 of 1
metal reamer
Posted: Sun Apr 13, 2014 7:57 pm
by frgna
I had some bart's arms anodized and now the hinge pins are too tight to fit - what kind of tool do I need to widen those a bit?
Re: metal reamer
Posted: Sun Apr 13, 2014 7:58 pm
by GoMachV
I use a .126 reamer from McMaster Carr, as recommended by Eau a while back. It's part number 8930A121 and runs about $14.50
Re: metal reamer
Posted: Sun Apr 13, 2014 8:16 pm
by DMAT
Since my dremel has a really small wobble, crappy dremel, my 1/8 bit adds in that extra gap lol.