RC10Talk - The Net's Largest Vintage R/C Community

Does anyone have an Associated worlds chassis they can measure?

I am wondering how wide the slots are? I cant tell from pictures if they are 3/8 or 1/2 inch wide

Also if someone can tell me how long the middle slots are that would be awesome.

I would like to know the total length from one end of the radius to the other.

Thanks!

I can measure tonight but it'll be late. If no one beats me to it I'll post it up then.

Width is .460
Inside rows are 4.5"
Out side is 3.865"

Best I can do with my Chinese mic. Hope it helps!!

The re-re looks the same, just stamped.

Bong024 wrote:The re-re looks the same, just stamped.

So the Re-Re chassis is not milled, its stamped? If that was stated elsewhere I must have missed it.

My original, you can see the swirls from being milled. Not present on the re-re.

Bong024 wrote:My original, you can see the swirls from being milled. Not present on the re-re.

As mine, but if the Re-Re was stamped, is there indentations on the bottom of the chassis that correspond with the top stampings.... just curious

No

The re-release is milled!

mikea96 wrote:The re-release is milled!

Thanks for the info Mike, I have not seen one, but that's what I thought.... going by pics.

I stand corrected. It just doesn't look the same as the original. I apologize for my misinformation.

Thanks for the info.