RC10Talk - The Net's Largest Vintage R/C Community

Hello, can someone explain me precisely how to cut and drill a team car chassis to fit properly the RPM kit? has someone a template?

I'm talking about this kit:



To fit on this chassis:



Thank you very much.

there is a drill and cut template out there.. i dont have one personally

I have one, if you like, I could lend it to you, but you'll be in charge of the double shipping fees (from Brussels to Nancy and back to me), just let me know

this is what you'll need.

I took a "Stealth Ready" Chassis and bolted it to the "6-Gear" Chassis, bottom to bottom, and drilled it that way. Seems to have worked just fine. Or is there some reason that shouldnt/wouldnt work (I havent actually driven it yet)?

MONSTER wrote:I took a "Stealth Ready" Chassis and bolted it to the "6-Gear" Chassis, bottom to bottom, and drilled it that way. Seems to have worked just fine. Or is there some reason that shouldnt/wouldnt work (I havent actually driven it yet)?

that template is to modify the rear of an rc10 chassis to use the worlds rear suspension. this is the template to drill for a stealth.

*anybody remember who Emily Latela was*
"Ooo, wel, that quite different...... Nevermind!!"


But, should the way I did the Tranny holes be OK?

I think I can do my own template with this picture, thanks.