RC10Talk - The Net's Largest Vintage R/C Community

I am sure i read it here b4 but can't find it now, as the title says are the chassis the same between the two? I noticed tbg are doing jrx pro undertrays an wanna double check b4 I grab one? I assume a cutout down either side for side link mounts if needed an it should fit a jrxt? Thanks everyone

the pro and T use the same chassis both can run H arms or 5 Link, the jrx2 uses a shorter chassis

Thanks mate,just as I thought, thanks for confirmation...

no problem thats what we are here for.

The early jrxt chassis does not have the slot for the servo saver because the servo saver was built into the bell crank. When the Jr pro was released, it used the rigid red bell crank....so a traditional servo saver was needed.

I thought the JRX Pro chassis was narrower, or was that just the Pro SE?

ProSE and it's truck version LXT were the first with narrow chassis, no more 5-link support.

Jirka

Here's some info on the different jrx chassis:

jrx2
graphite (no slot)
short wheel base
20 degree front kick
wide - can use the 5 link

jrx proformance kit
graphite (no slot)
long wheel base
30 degree front kick
wide - can use the 5 link

jrx pro
graphite with slot
long wheel base
30 degree front kick
wide - can use the 5 link

jrxt
graphite (no slot)
long wheel base
30 degree front kick
wide - can use the 5 link

junior 2 / junior t
composite with top brace (no slot)
long wheel base
30 degree front kick
wide - can use the 5 link

jrx pro SE / LXT
composite with top brace (no slot)
extra long wheel base for trucks and standard long for the buggy
30 degree front kick
narrow - cannot use the 5 link

Hope this helps...

Man, there is so much great information on here!

So I have a JrxT/Jrx-Pro chassis I came across that has a strange, bumpy texture to it. No "oreo sandwich" look either- appears to be solid carbon. Is it some aftermarket plate?

Thanks all!

You sure it is a long chassis?
Some early JRX2's had the textured chassis'

http://www.rc10talk.com/viewtopic.php?f=27&t=20654&hilit=JRX2+textured+chassis

Ok, I double checked and found that indeed I have one normal "oreo" T chassis and one solid carbon chassis with a light texture to the bottom of it. Not as wavy and shiny as the early Jrx2 plate. Subtle variation I guess.

I did find that I have one of those early Jrx2 chassis' also! Cool! I didn't know they were rare!

Thanks for the link.

Oh, and the center 2 battery holes on my texture plate are also ovaled out btw.