RC10Talk - The Net's Largest Vintage R/C Community

I need some schooling.

On my re release gold tub I'm thinking about getting a set of the Dhawk rear hubs.
I plan on throwing in the some 3/16" cva's (6371)
Which hubs should I get, the classic hubs (6365) or the worlds (7364)??
On the front end I'm gonna have wide arms and wide axles.

...............................

And in general, just so I have an understanding of things, if you just swap the worlds hubs on the classic or visa versa, how does that effect handling??

Worlds equivalent.

It shouldn't effect handling at all. Toe-in should be the same at 0 degrees and the location of the top link hole should also be the same. The swap is mainly to facilitate the use of unflanged bearings which the 3/16" axles require.