Page 1 of 1
McAllister Question answered......
Posted: Wed Jan 02, 2008 9:11 am
by mrlexan
I believe it was either tulsa or bscotti whom was wondering what the Wildcat looked like...... well during my travels, we finally know what it looks like. I will get the part number from the header card when I get home. Sorry for the poor quality photo and lighting, I was lazy (still in vacation mode).
Re: McAllister Question answered......
Posted: Wed Jan 02, 2008 1:18 pm
by wts873
Is that for the Kyosho wildcat?? I recently picked up a chassis complete except engine. I did not think the body looked like that.
Re: McAllister Question answered......
Posted: Wed Jan 02, 2008 1:39 pm
by mrlexan
No it is not for the Kyosho Wildcat. The Kyosho WC was a alum roll cage car that just a driver figure and a radio tub top and bottom..... not much of a body. McAllister just used the same name. The specific fitment, I am not 100% sure of, but I have seen the Wildcat 2 body on Kyosho Scorpions, RC10s, etc. As with anything, they can be fit to pretty much anything.
Re: McAllister Question answered......
Posted: Thu Jan 03, 2008 5:47 am
by Dr. Robotnik
Was this one that McAllister would still make?
Re: McAllister Question answered......
Posted: Thu Jan 03, 2008 7:09 am
by tulsa
Dr. Robotnik wrote:Was this one that McAllister would still make?
the last i talked to gary (about 4 months ago) he has not found any of the buggy body molds
Re: McAllister Question answered......
Posted: Thu Jan 03, 2008 7:21 am
by mrlexan
Back a few years ago when I had him pull some bodies for me, this was the one that he could not find.