RC10Talk - The Net's Largest Vintage R/C Community

Finally came in the mail!Plan on using this truck as a runner.It's been used hard which is fine by me and makes me not feel guilty about bashing it .I do plan on trying to keep it period correct on outside but updated underneath.She isn't much to look at now,but all in all I'm happy with it.
The chassis is a deep dark purple,not sure if it's aftermarket or someone had it done.It isn't paint.

As it sits:
Reedy 3300kv motor
XP700-bl speed controller
HiTec HS-311 servo
Rpm arms all around
Full sealed bearings
Titanium turnbuckles
CVD's
Carbon fiber trans plate
Aftermarket shock towers

Waiting for :
Flysjy transmitter with recievers
Turnigy hardcase Lipos
Meanwhile Im going to get it together to check that it runs,then disassemble to give it a good cleaning and lubricate,and rebuild the stealth
Here she is

I've searched but can't seem to figure out which wire goes where to motor.Anybody know?

With these reedy motors it doesn't matter which wire from the esc goes to which wire on the motor. When you plug it together, if the motor runs in reverse just swap two wires around and it should run forwards.

Good luck with the rebuild.

Hi Jeenhal,

Looks like a great project!

If you are not keen on the blue arms they can be dyed black.

Cheers, Dave.

Begin this one with other couple of projects. I have one that is in great condition, I began to dissect it to clean the parts and restore it into factory stock condition, yet other project in as a burden I'll be making custom suspension pieces out of aluminum, and ideally making a double motor. motor mount for some additional power.