Page 1 of 1
RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 1:29 am
by Spoon
I was very fortunate to have a chance to pick up this new built composite craft chassis kit with RPM worlds suspension from my LHS today. My question is did RPM make the worlds suspension arms in black or are these dyed ? Thanks in advance.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 1:51 am
by Beau S
All of the RPM worlds parts came in white.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 8:33 am
by Showcase1186
Hi spoon,
I was hoping you could help me by taking a measurement of you rear arm length from inner hinge pin to outer?
Thanx for any help
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 11:26 am
by shodog
I've only seen them in white. Killer score on that chassis.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 12:01 pm
by hugger19
they look like new rpm arms made in black. i think hard to tell from the pic.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 12:41 pm
by matteo
I have a set in both black and white. If my black ones are dyed, they are an exact match of RPM black parts.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 12:46 pm
by scr8p
All of the worlds parts came white.
Re: RPM worlds suspension question ?
Posted: Sun Mar 22, 2015 1:39 pm
by Spoon
Thanks so much for the help, the reason I asked about the color is because the owner of the shop didn't recall dying the components black. I've attached a few more pictures for a closer look.
The measurement of the rear arm hinge pin to pin is 2 33/64" on the set I have which I can only assume should be 2 1/2" given a +/- tolerance of 1/64".