Page 1 of 1
Re-Re Chassis Quality Question
Posted: Tue Mar 24, 2015 3:49 pm
by GeekSpeed
Hi guys.
I got my Re-Re in the mail yesterday and I am super excited. I am going to build it and shelf it next to my Cadillac. Anyway, I was looking over the chassis and it seems a bit... off. I have a few pictures. Should there be the ridges and bends that are in the pics? Should I contact Associated for a replacement? If this is normal, I won't worry about it. Thanks all!
Re: Re-Re Chassis Quality Question
Posted: Tue Mar 24, 2015 4:09 pm
by GoMachV
It's normal, the original has it too just not as noticeable.
Re: Re-Re Chassis Quality Question
Posted: Thu Mar 26, 2015 9:33 am
by RC10th
Made in the USA.......
One of the few parts anyways
Re: Re-Re Chassis Quality Question
Posted: Fri Mar 27, 2015 2:18 am
by Lowgear
They said the re-release parts were going to have slight variations to distinguish them from the originals. I guess typical dodgy modern craftsmanship does the trick.
Re: Re-Re Chassis Quality Question
Posted: Fri Mar 27, 2015 7:34 pm
by marlo
I find it very hard to believe that the re-re is of a lesser grade than the original. Should all be top notch stuff
Re: Re-Re Chassis Quality Question
Posted: Fri Mar 27, 2015 9:51 pm
by Beatnik
Lowgear wrote:They said the re-release parts were going to have slight variations to distinguish them from the originals. I guess typical dodgy modern craftsmanship does the trick.
Re: Re-Re Chassis Quality Question
Posted: Sat Mar 28, 2015 7:38 am
by Lowgear
marlo wrote:I find it very hard to believe that the re-re is of a lesser grade than the original. Should all be top notch stuff
I've read enough reports to make me feel that there were some substantial quality control issues. How about the top shaft dilemma? I'm not knocking the re-release at all, and would possibly like to own one in the future. I'm just sayin'.