Page 1 of 1
Works 91 spur assembly - wasp racing??
Posted: Thu Aug 25, 2016 5:23 pm
by _timmy_
Anyone have any ideas on this. Haven't seen one before...
Re: Works 91 spur assembly
Posted: Thu Aug 25, 2016 7:04 pm
by jwscab
Could be wasp or Schumacher. The gear is tufnol. More guys that know better will chime in.
Re: Works 91 spur assembly
Posted: Thu Aug 25, 2016 7:14 pm
by _timmy_
yes, a wasp torque limiting clutch has been mentioned. cant find much info anywhere on it to check though
Re: Works 91 spur assembly - wasp racing??
Posted: Tue Dec 27, 2016 6:04 am
by Welshy40
Rw racing in the uk still sell the spur gears and in white or black plastic should you need more.
Re: Works 91 spur assembly - wasp racing??
Posted: Tue Dec 27, 2016 5:11 pm
by _timmy_
You sure James? With the large centre cutout....the spur is more like a ring....haven't seen any anywhere
Re: Works 91 spur assembly - wasp racing??
Posted: Tue Dec 27, 2016 9:29 pm
by Peakey
I've got a WASP yoke slipper and it doesn't look like this it's like the ones that came on the Cats but this could be another design, have you got pics of it apart to see if it's the same inside?
Re: Works 91 spur assembly - wasp racing??
Posted: Wed Dec 28, 2016 4:02 pm
by _timmy_
I haven't but i'll strip it and post some tomorrow Justin
Re: Works 91 spur assembly - wasp racing??
Posted: Thu Dec 29, 2016 5:03 pm
by _timmy_
here it is...main body sits over the end of the layshaft incorporating a one way bearing, the the white plastic(?) disc doubles as the spur gear mount and slipper pad, then you've got the outer plate kept in place by a small plug inserted in the main shaft, 4 sprung washers and finally the outer round nut that acts as the slipper adjuster...that's it apart from what looks like they are going to be hard to source spurs!!....pics below