Page 1 of 1
my optima kit
Posted: Mon Sep 05, 2016 10:39 am
by saga101
Re: my optima kit
Posted: Mon Sep 05, 2016 11:29 am
by cyberfox
yeah!
It's an Optirpion or a Scorptima ?
Re: my optima kit
Posted: Mon Sep 05, 2016 11:36 am
by saga101
cyberfox wrote:yeah!
It's an Optirpion or a Scorptima ?
haha..
Re: my optima kit
Posted: Mon Sep 05, 2016 11:05 pm
by rccars4sal
Very cool! Whats with the chain tensioners? Are they to avoid the cross braces? I like the idea of scorpion trailing arms. Always figured a trailing arm conversion would be super cool. I like the idea of scorpion arms on a progress gallop frame too.
Re: my optima kit
Posted: Mon Sep 12, 2016 4:26 am
by saga101
Re: my optima kit
Posted: Mon Sep 12, 2016 10:34 am
by yellowdatsun
Not gonna work so great without a middle chain roller. It's going to eat up the cross brace and chain. If it's being sold like this, be prepared for some unhappy customers.
Re: my optima kit
Posted: Mon Sep 12, 2016 10:47 am
by saga101
yellowdatsun wrote:Not gonna work so great without a middle chain roller. It's going to eat up the cross brace and chain. If it's being sold like this, be prepared for some unhappy customers.
just a temporary I have replacement
Re: my optima kit
Posted: Mon Sep 12, 2016 10:58 am
by Coelacanth
The way it is currently, the angle of the rear upper chain area will chew away the upper plastic "flap" of the gearbox...and even worse, will probably bind if going in reverse. So you'll have to cut off that section of the gearbox. This will also permit dirt to more easily enter it. With the original belt conversion, a tiny gear was added to allow the belt to exit the gearbox pretty much perfectly horizontal. This design looks promising, but it will need more thought to the design. It's not a product that's ready for sale; unhappy customers will be the result.
Re: my optima kit
Posted: Mon Sep 12, 2016 11:45 am
by saga101
Coelacanth wrote:The way it is currently, the angle of the rear upper chain area will chew away the upper plastic "flap" of the gearbox...and even worse, will probably bind if going in reverse. So you'll have to cut off that section of the gearbox. This will also permit dirt to more easily enter it. With the original belt conversion, a tiny gear was added to allow the belt to exit the gearbox pretty much perfectly horizontal. This design looks promising, but it will need more thought to the design. It's not a product that's ready for sale; unhappy customers will be the result.
yes i know
Guide wheel The use is free
That reference parts
And you can to adjust the angle
Re: my optima kit
Posted: Tue Sep 13, 2016 8:21 am
by rccars4sal
Is it shorter wheel base? Looks great! have you run it?