RC10Talk - The Net's Largest Vintage R/C Community

Greetings,
I've looked at the instruction manual online but I can't seem to find a template for bending the front anti roll bar. Can somebody point me in the right direction please? The only pic I can find is this one but it doesn't look to helpful : http://www.oople.com/rc/manuals/xls/imagepages/xls14.html

Thank you

Hope this is usable

Thank you! That helps immensely.

This might help too

http://www.retromodelisme.com/scan_pages/229/cat-schumacher-page-5.html

Peakey wrote:This might help too

http://www.retromodelisme.com/scan_pages/229/cat-schumacher-page-5.html

Thanks. I didn't think of looking in the SWB manual. I know the xls came with pre bent wires. Did the xl come with pre bent as well?

Peakey wrote:This might help too

http://www.retromodelisme.com/scan_pages/229/cat-schumacher-page-5.html

Just a thought. Isn't the XL a little narrower than the XLS?

Pretty sure anti-roll bar never changed, until Bosscat came along and deleted it.

Danf1275 wrote:Pretty sure anti-roll bar never changed, until Bosscat came along and deleted it.

Ok, thanks