Page 1 of 1
Andy´s trailing arm build
Posted: Sun Feb 19, 2017 10:30 am
by DennisM
Thanks to Jeff for the fine chassis and rear shock mount
Are there any bodies especially for the Andy´s trailing arms?
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 12:09 pm
by DennisM
This is how it ended so far. replaced the "original" trailing arm rear suspension mount with a standard, and used some shorter shocks to keep the body low.
Please try to keep Your enthusiasm down this time - I know it´s hard, but please try and keep the comments to a minimum
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 1:11 pm
by GoMachV
Well "I" think it's cool!
Not quite A&L trailing arm cool....but cool
j/k
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 1:54 pm
by DennisM
Thanks for being supportive Jeff
As soon as I find that "New Owner" coupon code in my mail
I´ll buy a set
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 6:06 pm
by Mr. ED
You need a big white wing on the rear, and paint those nose tubes white
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 7:04 pm
by GoMachV
DennisM wrote: ↑Thu Mar 09, 2017 1:54 pm
Thanks for being supportive Jeff
As soon as I find that "New Owner" coupon code in my mail
I´ll buy a set
You didn't get that yet? Ugh. I'll talk to my IT person
Re: Andy´s trailing arm build
Posted: Thu Mar 09, 2017 7:58 pm
by klavy69
DennisM wrote: ↑Thu Mar 09, 2017 1:54 pm
As soon as I find that "New Owner" coupon code in my mail
I´ll buy a set
and a lethal weapon and traxxas dogbone setups and and and
As far as the buggy goes in the final product why did you change out the wheels Dennis? What did you do to mount the nose tubes to the chassis? I think it looks good as is but looked great pre-body shots with just the right amount of shelfer bling
Todd
Re: Andy´s trailing arm build
Posted: Wed Mar 22, 2017 10:57 am
by DennisM
klavy69 wrote: ↑Thu Mar 09, 2017 7:58 pm
DennisM wrote: ↑Thu Mar 09, 2017 1:54 pm
As soon as I find that "New Owner" coupon code in my mail
I´ll buy a set
and a lethal weapon and traxxas dogbone setups and and and
As far as the buggy goes in the final product why did you change out the wheels Dennis? What did you do to mount the nose tubes to the chassis? I think it looks good as is but looked great pre-body shots with just the right amount of shelfer bling
Todd
Well, since I had to replace the gold shocks because of the lenght of the rears, I took revenge and replaced the aluminum rims
The nose braces are bent 6mm aluminum rods.