RC10Talk - The Net's Largest Vintage R/C Community

I'm about 99% sure the answer is yes but the seller couldn't say for sure... I bought some rc10gt blocks a few months back that I was told would fit but apparently they are slightly off to mount on an rc10t.

Rc10 and 10t are the same. GT are not.

Thanks!

FYI Robinson Racing has 2.5 & 3.5 degree mounts in black. If color is not an issue then the re-re parts may be easier to acquire.

Where are the 3deg usually applied?

In the Arm mounts

or

in the hubs / hub carriers ?

What Part numbers do I have to hunt for?

Thanks, Tony

Hi,

The re-release arm mounts are 3 Degrees, ASC 6360, same toe in as the originals on the 10T Team Truck.

https://www.towerhobbies.com/cgi-bin/wti0001p?&I=LXDSXV&P=7

The Worlds rear hubs are 0 degrees, same as the originals on the 10T Team Truck, ASC 7364.

https://www.towerhobbies.com/cgi-bin/wti0001p?&I=LXEDZF&P=7

Did Associated change part numbers and possibly the specs on some parts?
According to the original 10T manual:
rear mounts, part # 6360 (does not specify degree of toe in, but Google pictures shows 1.5 deg on older packaged parts)
rear hubs, part # 7358, 3 deg of toe in

On my 10T, I have 0 deg mounts and 3 deg hubs. Attached is a picture of the spares I have, notice the part number on the mounts. That is what is now the rear hubs.

The original 6360's are 1.5. The re-release 6360's are 3.

Hi,

Team Associated made running changes, they also recycled some part numbers just to make things confusing,

and there was optional rear mounts and hubs.

ASC6360, 1.5 degrees rear mounts are in the #7001 kit.

ASC7363, 3 degree rear mounts are in the #7035 Team kit.