RC10Talk - The Net's Largest Vintage R/C Community

Hi

I have 2 Acoms AM receivers (AR-227FE) that I got in a lot of parts. I think they are brand new but when I tried to test them I could not make them work. I only have futaba servos so I think it could be a problem with the wire position on the connector. I don't need those and I'd like to sell them. Do I have to switch the wires around for those receivers? If so what position should be the red, black and white wire then?

Thanks for the help...

Acoms should be the same as Futaba, signal-positive-negative. Was usually only older Sanwa and KO stuff that had the negative in the middle.

Alex

Ok thanks