RC10Talk - The Net's Largest Vintage R/C Community

Hello RC10 fans! I was able to have NIXconcepts from shapeways.com fabricate the captured lower spring cup on the box art RC10. Go to shapeways.com and search for "RC10 Classic spring cup prototype 4pcs"
These are the first prototype captured lower spring cup that were made by NIXconcepts from shapeways.com. These prototypes have a slot to make installation easier. They are also a little bit thicker than the ones on the "box art" so I asked Niki at NIXconcepts to maybe shave off about a fourth of the thickness. We'll see.

Let me know what you think

Thanks jaeger for asking a special part. This was a nice tiny project.
There are now two different height versions available. 8mm and 9mm.
http://shpws.me/P7Ib
http://shpws.me/P7I9