RC10Talk - The Net's Largest Vintage R/C Community

I'm searching for a 3.2mm = 0.125" diam hinge pin with a lenght of 1.03"
I think that AE 6227 king pin is 1", but that is a tad too short for my application.

I have in my boxes one hinge pin that meassures 1,03" in legth, but I do not know whats it for. Could it be rc10ds, Losi or....?

Edit: Could be 6227.

Is it 1.03" overall, including the e-clip grooves?

If you give me the dimension inside the e-clip grooves I can make a pair out of titanium (all I have right now).

jwscab wrote: ↑Thu Mar 08, 2018 8:37 am Is it 1.03" overall, including the e-clip grooves?

If you give me the dimension inside the e-clip grooves I can make a pair out of titanium (all I have right now).

Oh damn. I measured it wrong.
I measured the total width at start.
So its not 6227 = 1.02"
I would need about 0.94" inside the e-clip grooves.
Thanks jwscab. I will hold on to that offer if I do not find stock ones.

ok. let me know....I'm on east coast USA outside Philadephia, so would need to ship from there, just fyi. In case you are able to find one closer or on the same continent.

Ha I found it!

Right before my eyes It's the outer front B2/B3 hinge pin.

Thanks jwscab!!