Page 1 of 1

RC12i/e speed control resistor value?

Posted: Mon Jul 30, 2018 10:21 pm
by ChuckW
Hey guys,

New member here and first meaningful post...I think.

Does anyone know what the resistance is on a stock 12i/e speed resistor should be? I've tried testing and old one with a volt/ohm meter and can't seem to be able to figure it out. I'm curious to know if I can use a Parma resistor intended for a slotcar controller as they are available in a wide range of impedance's and I'm sure one would probably work on an RC car.

Re: RC12i/e speed control resistor value?

Posted: Mon Jul 30, 2018 10:54 pm
by GoMachV
Typical rc resistors are 1 ohm or less, where slot car controllers are usually up over 4 ohms and up to 45 or so. Associated didn’t tell you the ohm rating like Parma did, but the Orange were for onroad and the green for off-road.

Re: RC12i/e speed control resistor value?

Posted: Mon Jul 30, 2018 11:01 pm
by ChuckW
Thanks for the info, that's good to know.