RC10Talk - The Net's Largest Vintage R/C Community

this lot poped up on facebook today for a whole 50$
blackfoot had what looks like a losi st body on it
can anyone id the other car looks Tamiya but it has a carbon fiber bottom plate


everything looks complete with electronics (excpt missing body )
came with 2 old futaba magnum sports
and big tool box of goodies
blackfoot looks like it has hot tricks alloy rear wheel hubs and there is paper work for a thorp diff set for the blackfoot (have yet to dig in and see if it is installed)

finished up the Blackfoot
didn't want a hard shell body and Parma's Blackfoot body was 35$ plus 10$ shipping (not paying 10 for shipping lol)

hit up the local hobby shop and found a jc f250 body made for the pede that looked pretty close to a good fit

printed a headache bar and some kc lights on my 3d printer (should have printed at a finer resolution / and done some extra prep work)

but I think it turned out pretty good for a quickie job


added some batteries and both cars run perfect also so im pretty happy