RC10Talk - The Net's Largest Vintage R/C Community

In admiration of 1300GT's 4wd SRB, I'm starting on my own attempt at building a similar car. I figured out a B4 slipper gearbox setup in this thread - https://www.rc10talk.com/viewtopic.php?f=32&t=44855

Now I'm mocking things up for the chassis. 2 3D printed replica MIP gearboxes, 3D Printed front arms, Optima front hubs, Scorpion trailing arms.

Cool. I really enjoyed that thread. Can’t wait.

Could you share the files for the 3D printed stuff?

Cool , can't wait for progress

Carknowledge101 wrote: ↑Sun Aug 16, 2020 2:15 pm Could you share the files for the 3D printed stuff?

Got it from this shapeways store, I believe the designer is a member
https://www.shapeways.com/shops/td3d

Cool!

I got the chassis cut out and suspension mounted. I'll have to make a roll hoop to mount the shocks in the rear. The motor is going to hang off the back Scorpion style.

I think the 3d parts will get dyed too, they get dirty if you handle them too much when you're mocking things up.

I'm conflicted , a Tamiya / Kyosho hybrid , its against all that's natural ! But I like it , I think I need to go to confession !

Made a little progress today

AscotConversion wrote: ↑Sat Aug 22, 2020 9:41 pm srb_rollbar.jpg

SRB_body_rollbar.jpg

Made a little progress today

Can you show the gears combination for reference? Where are the gears come from? Thanks

Gears are :
Rear:
topshaft- STRC B4 slipper shaft - https://www.amainhobbies.com/st-racing-concepts-cnc-machined-transmission-layshaft-sptst3793ae/p185515 - and this gear (which needs to be slotted to fit the shaft) - https://www.ebay.com/itm/Brass-Gear-tamiya-sand-scorcher-SRB-rough-rider-fighting-buggy-champ-super-champ/141736106916 -

idler - standard SRB topshaft

Bottom Tamiya SRB/Sand Scorcher ball diff

front:
idler - standard SRB topshaft

Bottom Tamiya SRB/Sand Scorcher ball diff

Pulleys are from the Kyosho Blizzard - B plastic parts set https://www.amainhobbies.com/kyosho-b-plastic-parts-set-kyobl7/p221429

freak'n awsome!

Why did this thread just end? I am not nice like Derek, need answer now?

I'm workin on it!

Just got some more aluminum tube to finish the cage. Unfortunately, remodeling my kitchen keeps getting in the way.

I also ground down the Optima front knuckles, as they are taller than SRB knuckles, and take away a little front end travel in stock form.

Pesky real world problems slowing down a good project