RC10Talk - The Net's Largest Vintage R/C Community

Can anyone tell me where this large bushing goes?

I had taken apart a 6-gear transmission for an RC10 I purchased because it was very crunchy, slipped and had no diff action (no counter rotating). So I ordered a set of bearings and diff balls, put all the Transmission parts on a zip lock bag and waited. The wait turned into a few months as kept working on other projects even after I had received the parts.

I finally had some time and re-assembled the 6 gear transmission carefully following the instructions. I have all of the bushings that were replaced by ball beatings but was left with this big one. For the life of me I don’t remember where it goes and can’t find it in the pdf.

Anyone know?

Bushing for rear axles, replaced by two flanged bearings

Wow thanks for the fast response. That must mean I have a second large bushing somewhere since I put bearings on the outdrives.