RC10Talk - The Net's Largest Vintage R/C Community

I have searched on here and found like 6 posts with not much info about this buggy
would any one care to comment
when it was made
how did it run
junk stay away
whats its story
thank you for your time
marty

This is my go-to page for initial info on any RC car. (Only one I haven't found on there is the Serpent Impact first generation.)
Most other stuff is on there.

https://www.rcscrapyard.net/kyosho-wildcat.htm

This is what it says:

History and Info for the Kyosho Wildcat:

Released by Kyosho circa 1980, the 2WD Circuit 10 Wildcat Buggy - # 3026 - has a formed alloy plate, with a plastic tub chassis, a cast alloy gearbox, coil spring over oil filled dampers and dogbone drive-shafts.

The same Circuit 10 chassis was also used for the Fiat 131 Abarth Rally, Mercedes 450 SLC and Baja West Coast.

Just to add to my previous post, having looked at a few online pages with detailed pictures: I have no clue how they handle, run, or how reliable they are, but from the pictures I've seen it looks awesome. It probably runs and handles awfully; it looks heavy and unbalanced. But it looks like it's built like a tank; all metal and full metal roll cage. If one showed up locally and in decent condition I would try and get it.

Hey thank you for the link lot of good info over there
marty