Robitronic Avid V1 - Inox A2 Version by me
Posted: Sun May 23, 2021 5:15 am
Hello everyone,
Here is my personnal vision of a car that made me fall down again into RC after long time break...
The outcast Robitronic AVID V1 (there is a V2, i 'will show you this one later)
https://www.rcscrapyard.net/fr/robitronic-avid.htm
On 2007, i bought the little sister of the AVID V1, the SCALPEL 1/18 pan car kit (i'll show you my personnal vision of it later too
) . In the same brand i falled in love with the AVID, abd on the end of 2009, i got two chassis !!!
It's like a pièce of engineering as i like, the mix between carbon and alloy is just perfect.
Robitronic was one of the only brand i practiced on removing anodising and polishing, that it was a pleasure to see all the original anodising parts are with the same grade of color.
On 2010 i start to Remove anodising (for the first time) on this car.
My goal is to hop up this chassis at is maximum
The beginning :
The first view after re-build :
All screws were swapped by Inox A2 ones, low-friction belts were installed, and i need a rear diff.
More to come
Jerome
Here is my personnal vision of a car that made me fall down again into RC after long time break...
The outcast Robitronic AVID V1 (there is a V2, i 'will show you this one later)
https://www.rcscrapyard.net/fr/robitronic-avid.htm
On 2007, i bought the little sister of the AVID V1, the SCALPEL 1/18 pan car kit (i'll show you my personnal vision of it later too
) . In the same brand i falled in love with the AVID, abd on the end of 2009, i got two chassis !!!It's like a pièce of engineering as i like, the mix between carbon and alloy is just perfect.
Robitronic was one of the only brand i practiced on removing anodising and polishing, that it was a pleasure to see all the original anodising parts are with the same grade of color.
On 2010 i start to Remove anodising (for the first time) on this car.
My goal is to hop up this chassis at is maximum
The beginning :
The first view after re-build :
All screws were swapped by Inox A2 ones, low-friction belts were installed, and i need a rear diff.
More to come
Jerome
