RC10Talk - The Net's Largest Vintage R/C Community

Hello all!

Just pulled my cars out of storage and am needing a body to fit an RC10 with the RPM Ultra Chassis, such as here:

https://www.rc10talk.com/viewtopic.php?t=584

I do remember that Losi SE buggy bodies fit it, but I can't seem to find any of these. Does anybody know where I might find a body currently in production (or with reasonable stock) to fit this thing?

Thanks!
Colin

Couple of reproductions currently on eBay

You can use pretty much any RC10 body on it. If you have the RPM Worlds rear tower, then you can go with the Pro SE body.

creese wrote: ↑Wed Sep 08, 2021 5:20 pm I do remember that Losi SE buggy bodies fit it, but I can't seem to find any of these.

That is what I ran, only bodies that fit the side profile of the chassis properly were the Losi bodies...I did use an RC10 body for a little while with an undertray but didn't like the fit so Losi it was...

The TOP Models Hybrid bodyshell was specifically made to fit the RPM chassis... but not many about (understatement).


https://www.rc10talk.com/viewtopic.php?f=33&t=43902&p=524080&hilit=top+models+hybrid#p524080

I posted this picture in a different thread. This is the eBay picture from penguin bodies for their JRX Pro SE body. Here actually on the RPM chassis.