RC10Talk - The Net's Largest Vintage R/C Community

Hope I’m ok to post this here. Hard to find the below parts wondering if anyone can help? Another question about the CVA as well: I have a ASC 9911 - B44.2 center/rear CVA bone could I just get a longer dog bone (I.e. just the dog bone from a B44) and use it with the other 9911 parts? Are the rest of the parts the same dimensions? Trying to convert Goldpan to a B44 rear to increase track width.

ASC 9756 rear B44 CVA
ASC 9608 wheel spacers

Thx!!

If you mean all of the cvd parts, the pins and spools and set screws, yes they should all fit. You just need to be sure the ball and sockets match up. There are both versions depending on what bone/axle you are using. Ie cup on bone or cup on axles.

You might try these if you still need ASC 9608.
GoMachV on this forum is Factory Works.

https://www.ebay.com/itm/303748279630?hash=item46b8ceed4e:g:7qcAAOSwibJfPXPv