The ultimate Mini JRX2 thread

[WriteDean]

Amazing! I am going to go broke with this little buggy!

I just can’t stop. The floodgates have opened.

These are our vintage A&L towers and the Agi Jammer conversion all shrunken

[juicedcoupe]

IMHO, the two side body posts are adequate.

[GoMachV]

Functionally yes, but it just doesn’t look right unless it has that itty bitty body mount stud

[clm]

Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol

https://cults3d.com/en/3d-model/game/losi-truck-style-body-mounts-for-the-mini-jrx2-work-in-progress

updated chassis pic heh...

Going to do the h-arms after the chassis, although I need to get a set of hinge pins and rear links to make sure I get them right.

[WriteDean]

Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol

https://cults3d.com/en/3d-model/game/losi-truck-style-body-mounts-for-the-mini-jrx2-work-in-progress

updated chassis pic heh...

Going to do the h-arms after the chassis, although I need to get a set of hinge pins and rear links to make sure I get them right.

Great work!!!

[clm]

The front kickup has not been sized right and I have not modeled any holes yet but dang if the trans and battery holder did not drop right in! Yes Yes I know I still need to do the bellcrank mounts, this was just a sizing test

There are some mounting holes by the rear bulkhead that got overridden by the longer length of the mini rear bulkhead, I only ever knew these to be used by the RPM esc mount so I will probably slide them forward a bit.

Oh on another note... the junior chassis with no ribbing on top is exactly the same layout as the T and the Pro for the most part.. I bet it would be flimsy but you could do a shelfer lol

Edit#2 the junior chassis is only very slightly different then a LXT/ProSE chassis, trim the sides, extend the tail one hole length..

[GoMachV]

Nicely done!

[BattleTrak]

Added silver Mini T 2.0 springs. Drained the oil out of the shocks and removed esc for a cleaner look.

[BattleTrak]

Make nylon wheel nuts! Take a regular 4-40 nut, drill center out with a 9/64 bit and thread on.

[GoMachV]

Those look great. I picked up some 6/32 to use but they still didn’t look quite right. The 4/40 are perfect

Now you need to find some 2mm for the shocks

[BattleTrak]

I got the idea from you and just looked around at what I had..lol

[clm]

You could always print some nylon nuts if push comes to shove

[WriteDean]

Decided to go brushed modified like an old school racer...

[GoMachV]

I like it! Where did you find an open endbell 370?

[WriteDean]

I have had it for years - nearly tossed it several times. It is the perfect speed too - video footage soon!