Page 1 of 1
metric rear rc10 hubs
Posted: Fri Jul 22, 2022 11:02 am
by JosephS
I happened into a set of bones and axles that look like they fit a 10t, same length as stock side by side, but the axles are metric. Are there any hubs that would be close enough to the same off set and height, but are metric? Something like ruster/slash hubs?
I had some B6 hubs but they are very wide compared to the original rc10 hubs.
I've not had awesome success enlarging bearing guides in stock associated nylon in the past. I may try it for this low class build, but I'd rather just buy a part that would work
Re: metric rear rc10 hubs
Posted: Fri Jul 22, 2022 3:04 pm
by jwscab
Look to a kyosho or Tamiya car, or possibly yokomo. They might have something with a closer offset than the newer cars
Re: metric rear rc10 hubs
Posted: Fri Jul 22, 2022 4:04 pm
by juicedcoupe
This is a Traxxas carrier beside one from a 10T. They are the common 2WD version from the Stampede, Rustler, Slash, and others.
It isn't perfect but could probably be made to work.
You can also mix and match 3 and 4mm thick bearings to shift the axles one way or the other (this is an older 8mm bearing version but the newer ones use 11mm bearings).
Re: metric rear rc10 hubs
Posted: Fri Jul 22, 2022 10:24 pm
by JosephS
juicedcoupe wrote: ↑Fri Jul 22, 2022 4:04 pm
This is a Traxxas carrier beside one from a 10T. They are the common 2WD version from the Stampede, Rustler, Slash, and others.
It isn't perfect but could probably be made to work.
Screenshot_20220722-145745_Gallery.jpg
Screenshot_20220722-145734_Gallery.jpg
Screenshot_20220722-145720_Gallery.jpg
You can also mix and match 3 and 4mm thick bearings to shift the axles one way or the other (this is an older 8mm bearing version but the newer ones use 11mm bearings).
Awesome. Thank you once again. You should be running a hobby shop.
Re: metric rear rc10 hubs
Posted: Mon Aug 08, 2022 11:53 pm
by JosephS
JosephS wrote: ↑Fri Jul 22, 2022 10:24 pm
juicedcoupe wrote: ↑Fri Jul 22, 2022 4:04 pm
This is a Traxxas carrier beside one from a 10T. They are the common 2WD version from the Stampede, Rustler, Slash, and others.
It isn't perfect but could probably be made to work.
Screenshot_20220722-145745_Gallery.jpg
Screenshot_20220722-145734_Gallery.jpg
Screenshot_20220722-145720_Gallery.jpg
You can also mix and match 3 and 4mm thick bearings to shift the axles one way or the other (this is an older 8mm bearing version but the newer ones use 11mm bearings).
Awesome. Thank you once again. You should be running a hobby shop.
it looks like the Losi sct 22.0 hubs work as well.