RC10Talk - The Net's Largest Vintage R/C Community

Does anyone know if the 7380 axles 3/16" mip for the t2/t3 /
customworks short can be substituted for the

b4 part 9598?

Other than being shorter, so you can't run the aluminum wheel spacer between the pin and hub like the B4, they should be the same.

scr8p wrote: ↑Mon Jan 23, 2023 7:47 am Other than being shorter, so you can't run the aluminum wheel spacer between the pin and hub like the B4, they should be the same.

Thanks. I only saw the part number differences after I bought a set of axles. Would I just need some shims to run pins on that setup?

So you have the B4 axles?

Yeah, you'll just have to add more shims. Or find the proper aluminum spacers.

scr8p wrote: ↑Mon Jan 23, 2023 11:49 am So you have the B4 axles?

Yeah, you'll just have to add more shims. Or find the proper aluminum spacers.

Opposite I have b4 bones and the customwoks axles. I'm gathering the parts for a b4 build.

Ideally you'd want the longer B4 axles and the #9608 spacer.

Not sure what custom works has but alternatively you could use these from Jeff which is a readily available replacement for the #9608. Mind you the spacers won't work with the shorter axle.

https://www.ebay.com/itm/303748279630