Page 1 of 1

A&L Body fitment

Posted: Fri Jun 16, 2023 9:43 pm
by RichieRich
Hey guys! Years ago, I built an RC10 with the A&L C2 chassis set. I originally put a ProTech II on it with the rear of the body going over the top of the shock tower. I thought the body looked too high so I trimmed the back off to lower the body. It came out fine but my creative trimming was too excessive. I'd like to put a different body on it now. I do have another ProTech II to use but I'd rather not. The reason it's a good body is because it's very wide so the chassis doesn't really protrude from the bottom. Of course I didn't notice this initially and purchased a JConcepts Detonator Worlds which is too narrow. What are you guys using? Or do you have any suggestions?

Re: A&L Body fitment

Posted: Fri Jun 16, 2023 10:22 pm
by GoMachV
The most readily available body that fits well is the Andy's Renegade. It has the wide front that works great with the chassis width and the tall area over the rear tower as well

Also, Boki sells a Protech II just in case you hadn't seen it.
https://www.bokiracing.com/product-page/boki-protech2-protech-rc10-team-associated

Re: A&L Body fitment

Posted: Sat Jun 17, 2023 5:40 am
by juicedcoupe
If you can find one, I think the Andy's Pro Arrow fits as well. He does a batch every now and then.

Re: A&L Body fitment

Posted: Sat Jun 17, 2023 7:23 pm
by RichieRich
Do I contact Andy directly to get either of these bodies or does he have an ebay store? I like the Renegade. Both look like they are wide enough in the front.

Re: A&L Body fitment

Posted: Sat Jun 17, 2023 8:10 pm
by GoMachV
I'd reach out on ebay, his store name is andysrcpaintusa. There are none listed currently.

Re: A&L Body fitment

Posted: Sat Jun 17, 2023 10:13 pm
by Frankentruck
These are some of the recent one's he's sold
Screenshot_20230617-211150.png