RC10Talk - The Net's Largest Vintage R/C Community

I've been looking for the PanaVise Part# 345 Grooved Aluminum R/C Car Chassis Jaws for a while now but they all seem to have been completely sucked into a black hole.

https://www.worthpoint.com/worthopedia/panavise-375-hobby-vise-rc-cars-1910087189

I even contacted PanaVise but they didn't know anything about them. They still make every single other part except those aluminum jaw attachments.

So I guess I will have some made or has someone already done so?

A set of grooved jaws on the the wide head is useful for way more than R/C stuff, especially alternative material ones such as Delrin.

I've had this thing sitting around in my RC stuff for years... never knew what to mount it to, so never used it.

That's a nice variation on the PanaVise 366 head.



If the shaft is 5/8" then it will slot right into a 300 series base.