RC10Talk - The Net's Largest Vintage R/C Community

I just bought this Jrx Pro SE on E-bay ant it had this front end on it can anyone tell me about it? it is all alum. thanks Rick

Dialled Racing front arms and a Corally front bulkhead, I had them a few years ago on this car before I sold it...

yea, those are really bad for the car, may infect your whole collection....if you send it to me, I will insure your other cars remain safe...





Good purchase, I was watching that one to see where it went.

It had alot of nice parts on it but the chassis was a very cut up Junior two and it was pretty worn. still I am very happy with it. I have replaced the chassis already and am makeing a nice runner out of most of the peices. parting out some of it to finish a beater car I am putting on Ebay. I will concider posable trades on that front end. thanks Rick

bearrickster wrote:I will concider posable trades on that front end. thanks Rick

Rick, what are you looking for?

I am looking for a Retrofit trans's for my Pro SE and LXT. Factory gear sets. and Mip dogbone set ups for my JRX pro and JRXT trinty alum. ft bulkheads the one for the GTX will work. and some hinge pins. I like the Lunsford ones their again the ones For the GTX work thanks Rick

I will get back to you later this eve. We should be able to work something out.

bearrickster wrote:I am looking for a Retrofit trans's for my Pro SE and LXT. Factory gear sets. and Mip dogbone set ups for my JRX pro and JRXT trinty alum. ft bulkheads the one for the GTX will work. and some hinge pins. I like the Lunsford ones their again the ones For the GTX work thanks Rick

If you have the retrofit tranny, the MIP XX CVD set works perfectly on the jrx*

I know, 'caus I got my bro set up with them.

thanks Rick