RC10Talk - The Net's Largest Vintage R/C Community

Hi everyone, new to Rc10 building.

I have this composite craft chassis with composite craft shock towers and front/rear Andys arms and stealth trans.

I need turnbuckles- but have no idea what to order- lengths - also would like to get something true to the vintage if possible, sticking with the after market theme

Then of course ill need ESc and motor- this will be a runner for fun so im thinking brushless with some power.

Thanks for any suggestions

Welcome!

Schumacher 3mm turnbuckles look a lot like Lunsford Punishers (no longer available) and Schumacher is available in titanium or steel.

My measurements look like:

Front - pair of 35mm, 45mm;
one 24mm and 30mm

Rear - pair of 24mm

https://www.amainhobbies.com/search?cID=&s=schumacher+turnbuckle

Frankentruck wrote: ↑Fri Nov 10, 2023 1:41 pm Welcome!

Schumacher 3mm turnbuckles look a lot like Lunsford Punishers (no longer available) and Schumacher is available in titanium or steel.

My measurements look like:

Front - pair of 35mm, 45mm;
one 24mm and 30mm

Rear - pair of 24mm

https://www.amainhobbies.com/search?cID=&s=schumacher+turnbuckle

Those look good thanks for the link. As for sizes, would your measurements be similar to mine same set up? or does it matter?

I have an original gold pan and they are much to short.

Thanks

I forgot to add my picture. My measurements are for a gold pan setup on a graphite chassis with Andy's front arms.
.