RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Tue Jan 21, 2025 11:14 am**

Hello all,

Bought an almost mint condition 1980s Nikko Be Young 4x4 for my 7 year old son.

Was great fun, but after around 30 mins of use, the front wheel drive stopped working. Prop shaft to front not turning so seems to be problem in the rear gearbox. Anyway, we found that even on the ice here in Sweden it had loads of traction and was fantastic fun just in rear wheel drive!

Jump forward another day or 2, suddenly steering to the right stopped working, rendering it obviously undrivable.. Gutted!

(We bought it for 70 euros just a few days before)

There is no physical damage to any of the steering components, and have split open the electromagnet coils and all seems physically fine. No breaks in wire etc.

So, all I'm left thinking with my almost no knowledge of electronics like this is that some component or components have failed.

New batteries tested yes.

Any of you have any suggestions before it goes to the tip?

I wanted to attach a photo of the car here but cannot see how.

Thanks in advance!

Woody

Posted: **Tue Jan 21, 2025 11:41 am**

Woodymk3 wrote: ↑Tue Jan 21, 2025 11:14 am Hello all,

Bought an almost mint condition 1980s Nikko Be Young 4x4 for my 7 year old son.

Was great fun, but after around 30 mins of use, the front wheel drive stopped working. Prop shaft to front not turning so seems to be problem in the rear gearbox. Anyway, we found that even on the ice here in Sweden it had l,oads of traction and was fantastic fun just in rear wheel drive!

Jump forward another day or 2, suyddenly steering to the right stopped working, rendering it obviously undrivable.. Gutted!

(We bought it for 70 euros just a few days before)

There is no physical damage to any of the steering components, and have split open the electromagnet coils and all seems physically fine. No breaks in wire etc.

So, all i'm left thinking with my almost no knowledge of elecronics like this is that some component or components have failed.

New batteries tested yes.

Any of you have any suggestions before it goes to the tip?

I wanted to attach a photo of the car here but cannot see how.

Thanks in advance!

Woody

Photos are going to be a great help. The prop shaft issue may be solved by simply disassembling and reassembling the gear box to make sure nothing popped out of place.

The steering stopping in a single direction could be a variety of things. Does it move even a little or make noise when you turn it?

Posted: **Tue Jan 21, 2025 11:54 am**

Thanks for your reply!

Nope, no noise, no attempt to move, nothing.. its just limp that way, but lever springs there fast and strongly the other way..

Posted: **Tue Jan 21, 2025 4:52 pm**

Woodymk3 wrote: ↑Tue Jan 21, 2025 11:54 am Thanks for your reply!

Nope, no noise, no attempt to move, nothing.. its just limp that way, but lever springs there fast and strongly the other way..

I'll leave it here to see if anyone else could chime in. My best guess is that it would take some electronic knowledge to fix. Can you check that the controller doesn't have a broken wire on the steering control?

RC10Talk - The Net's Largest Vintage R/C Community

Nikko Be Young - can it be fixed?

Nikko Be Young - can it be fixed?

Re: Nikko Be Young - can it be fixed?

Re: Nikko Be Young - can it be fixed?

Re: Nikko Be Young - can it be fixed?