Page 1 of 1
RC10GT Spur options
Posted: Sat May 10, 2025 1:55 pm
by Ty89m
My kit spur on the re-re GT has a fair bit of runout. Does the TA/Kimbrough (part 7662) play nice with the re-release? It's hard to tell if the center hole is correctly sized for the slipper plate/bearing.
Re: RC10GT Spur options
Posted: Sat May 10, 2025 6:41 pm
by RogueIV
FWIW, I've used Kimborough spurs on my other reres and it worked fine, I'd hope AE wouldn't decide to go with something nonstandard on just the GT.
Re: RC10GT Spur options
Posted: Sat May 10, 2025 8:29 pm
by RC10th
32 pitch could cope with copious amounts of runout.
Re: RC10GT Spur options
Posted: Mon May 12, 2025 12:36 pm
by Ty89m
RC10th wrote: ↑Sat May 10, 2025 8:29 pm
32 pitch could cope with copious amounts of runout.
With some messing about I managed to reduce the runout quite a lot, so we'll see how I get on. I'll likely order one of the older black/Kimbrough spurs just to check fitment as well.
Re: RC10GT Spur options
Posted: Mon May 12, 2025 1:30 pm
by Mark Westerfield
Kimbrough spur gears work fine.