RC10Talk - The Net's Largest Vintage R/C Community

I have a Pro SE with mismatched front arms. Looks like it has one JRx2 Arm and one Pro SE arm (broken). Since Pro SE arms seem hard to find, can I use a modern arm (like a XX or XXX) instead?

Unfortunately, the arms from the newer cars are too wide. Let me check to see what arms I have...I thought I had some for the pro se.

regards,
highwayracer

I think I have one extra.... I want to say last time I looked at it, it was a bit different than the ones installed on my car. By that I assume there were two versions. You can have it if you like.

Yes the Jrx 2 arms will work I have 1 single arm also let me know if you need it. I just bought a Se on E-bay it had XXX arms on the front he had to cut down the front bulkhead it worked but I would have cut it in the back he removed the mat. from the front so the arms are a little far back for the shocks.

Just by looking at that pic above I am pretty sure, that those xxx arm are way too long. Ithink I have a pair of swept arm I don't really need. But I've seen front JRX-2 arms around evilbay often enough. The cool thing about the original front arms is that there ain't no left or right.

I know not cheap, but you might want to give THESE
a try. Indestructable rpm arms, those are also on my bro's Jrx ProSE.

Yes they were quite wide the whole set up was scraped and replaced with new stock swept arms and new bulkhead I was just showing how the XXX arms fit on this car, or dont fit is more to the point they arent a very good idea on the Jrx cars. thats all.

Merry X-mas:

http://www.ultimatehobbies.com/istar.asp?a=6&id=LOSA1013!1002

Maybe they actually have it?

bngiles wrote:Merry X-mas:

http://www.ultimatehobbies.com/istar.asp?a=6&id=LOSA1013!1002

Maybe they actually have it?

I may have to drive over there and see....