RC10Talk - The Net's Largest Vintage R/C Community

I did not properly store my parts. Working to identify my original parts vs new ones.

Can someone check if the edinger parts have the same gate and release pin marks?

The gate point on the original is in the center
The ejection pin points are all along front edge of the part on the original The seam is on the same place on both parts . The crack indicates why I replaced this part.

While the sway bar on my Edinger is blocking the topmost pin mark the rest of the pins and gate are in the same places as your Cadillac.

Neat comparison, some sort of database between AE and Fan RC injection molded parts would be pretty cool.

Would be neat, but there are now so many runs of the rc10 it’s going to be hard to keep track. There was the forts re-release as well. I noticed that in the early print manuals you can see the gating.