RC10Talk - The Net's Largest Vintage R/C Community

I am now the shelf proclaimed expert, able to build in record time I might add, of the X2 family of trannies. Here is the pics of what I currently don't have installed in vehicles...... this pic DOES NOT show the 8 I have installed in vehicles, the one that was sold in my Pro SE, and the Retro I traded. That is 23 total and I still have a couple I could build from parts. I don't think I want to see another Losi trans for a while now.

what's about the top black one with the reversed motor plate? were you too tired after 22 build-ups? Oh, and when did that grey case appeared?

where is the yellow motor plate?
Were they all built up from NIP parts, or re-built/restorations?
The grey case I beleive came on the later versions of the junior2/T I have a NIP junior-T (somewhere in the mess) and I think it has the black case.

I am not sure of the dates of the grey trans, but the last few runs through the mold appear to have been done in grey. I too have a Jr T that had a great case. Most of what is still on the shelves if you can find them are done in great as well and come with the green/blue losi tag (the latter of the tags).

The reversed one is a custom Hyperdrive installed setup.

The yellow plate hasn't shown up yet. It is going to replace the litesink on my RPM-X2 when it shows to stick with the yellow theme.

There is a mix of new builds and restorations. The restos where torn down, tossed in a bath of Simple Green and scrubbed. I replaced parts as I needed to. Of course most of the new build from parts went into the vehicle builds (pics of those coming soon).

WOW those retro fitted sure are nice. Planning to part from any?

I think you need some more trannies. And by trannies, I mean transmissions.

Wow I am sure I could find good homes for some of those!! nice collection Mr Lexan

I still have nine chassis plates asking for some of them. The rest will likely end up for trade or on ebay. Always game for good trades.

that is a lot of tranmision's