Page 1 of 1
question
Posted: Mon May 19, 2008 8:29 pm
by scr8p
an rc10t rear shock tower, and a rc10gt rear shock tower. are the 2 lower mounting holes in the same position? more or less, i want to mount a gt tower on an rpm 10t bulkhead. thinking about it, anyway....................
Re: question
Posted: Mon May 19, 2008 8:41 pm
by shodog
Composite craft marketed the same shock tower for both trucks. However I needed to drill holes in my chock tower to fit it to an RPM bulkhead.
Re: question
Posted: Mon May 19, 2008 8:50 pm
by scr8p
shodog wrote:Composite craft marketed the same shock tower for both trucks. However I needed to drill holes in my chock tower to fit it to an RPM bulkhead.
the bottom holes? i know you need to drill 2 new uppers.
Re: question
Posted: Tue May 20, 2008 11:47 am
by bscotti
I believe the bottom 2 holes are the same, but I'm going off memory. I was test fitting the same combination of parts.
Re: question
Posted: Fri May 30, 2008 5:22 am
by GAMMACRUSH
i used a GT rear tower on this 10t. the two bottom holes lined up, but they are slightly off. just a very small amount, i had to put the screws in at a slight angle.
Re: question
Posted: Fri May 30, 2008 5:22 am
by GAMMACRUSH
GT tower, bottom holes:
Re: question
Posted: Fri May 30, 2008 5:40 am
by GAMMACRUSH
10t tower, bottom holes:
peace, gamma