Page 1 of 1
Chromie Vs a .050'' Allen Wrench.
Posted: Thu Oct 16, 2008 10:25 pm
by Chrominator
I was real bored the other day , so I decided to have some fun with a .050'' Allen Wrench and a CVD, and this is the end result. LOL
The wrench broke off and then proceded to go in one end of my finger and out the other.
I guess it's 1/0 Allen Wrench.
Re: Chromie Vs a .050'' Allen Wrench.
Posted: Thu Oct 16, 2008 10:35 pm
by scr8p
ouch! in and out, huh?
well, you know what they say. anything worth doin' is worth doin' right.
Re: Chromie Vs a .050'' Allen Wrench.
Posted: Fri Oct 17, 2008 3:07 am
by Halgar
I've had similar predicaments with nail sets (trying to divot a ceramic tile ) and phillips apexes in a drill while driving screws. The nail set exploded and sent the tip deep into my finger, the drill apex jumped out of the screw head and with the force I was applying to the drill, mashed it through my finger. Neither incident felt very good, to say the least.
A similar event, I once had a blackberry thorn (the sticker bush, not the electronic hand held device ) break off in the pad of a finger, travel through the finger and pop out beside the finger nail. This took about two weeks, the whole time I knew something was in my finger, I just couldn't find it!
I was lucky that it popped out beside the fingernail and not under the nail or worse. The thorn was just over 1/4" long. It was a very painful two weeks! LOL