RC10Talk - The Net's Largest Vintage R/C Community

Look what i got today PT2

If anyone has parts for cougar 2000 please let me know - i might fancy to build one based on that tub & parts. I also got different comcom c2k chassis' and all woven cf parts one could think of.

If you ever want to sell it let me know , i am looking for ages for a c2k carbontub chassis.

This is a my ComCom carbonfibre C2k


This is a old pricelist from 1993 off the cougar2000



And this is the cougar i sold many years ago

Very nice cougar there Jeroen ! I also have the complete kit and single parts yours is based on ! I am currently thinking of building one based on the tub, i'd therefore be interested in trading the comcom parts for c2k parts to build one.

I'm not after any COMCOM parts, but if either of you have any genuine Schumacher C2K carbon fibre parts for sale, please let me know

sorry - only comcom but if you want to get rid of C2K parts (everything besides cf parts) i would be your man !

here is everything you need
http://www.oople.com/forums/showthread.php?t=15814

That guy sold his Cougar 2000 after 20 minutes... (not to me)

jeroen206 wrote:here is everything you need
http://www.oople.com/forums/showthread.php?t=15814

Thanks Jeroen, i am also viewing some on ebay, they are very cheap actually. But on the other hand i'd actually like to build one based on new parts.

Tub is gone - found a caring home for it Complete chassis kits & comcom parts will go on ebay or BST area.

My new project

Jeroen, have you got any pictures of the top of your old Carbon Fibre Cougar? I'd be interested to see what you used to support the rear upper chassis. I had to cut a chassis "gate" up to make two rear supports. Also I noticed I've got some empty screw holes in the front upper & lower chassis that are used on your old car. I've marked up the ones I mean. Can you remember what they were for? The forward pair must be the servo, the other pair of holes are for the chassis gate with the battery clip on.

hi ian

It is looking great that Tubchassis .
I really don,t know what the use was off these holes.
But i had a one piece upperdeck on my Cougar2000.

Got a bit further with the tub project. Fitted Lunsford turnbuckles & built the gearbox with original diff outdrives for the old-school tubular alloy driveshafts. Trying to decide whether red or silver parts look better. Everything is/will be NIP except the motor plates - both are more used than I'd like but I can't find a new one anywhere

Silver ! Bling is for cougar 2

I would use the red motorplate and some plastic driveshafts (U1511)

jeroen206 wrote:I would use the red motorplate and some plastic driveshafts (U1511)

also a good idea !